RetroRGB Interview: Ace
RetroRGB8 Elo 2018

RetroRGB Interview: Ace

Here's an interview with Ace; Genesis aficionado, clone console tinkerer, fellow retrogaming nerd like the rest of us! Check out links to Ace's work below, as well as FLAC audio samples as discussed in the interview. Please support the Patreon: https://www.patreon.com/retrorgb

FM Sound Chip Samples: http://www.retrorgb.com/files/Genesis_DAC_Noise_Samples-YM2612vsYM3438.zipMy page inspired by Ace's work: http://www.retrorgb.com/genesisversions.htmlAce's Genesis board research: http://www.sega-16.com/forum/showthread.php?7796-GUIDE-Telling-apart-good-Genesis-1s-and-Genesis-2s-from-bad-ones

Ace asked if I'd post these minor corrections to the interview:

17:25 - A CMOS device can both source and sink current, and while an NMOS gate typically sinks current through a pull-up resistor, the YM2612's DAC outputs SOURCE current through 2.2Kohm pull-down resistors connected to the analog outs. In short, both the YM2612 and YM3438 source current, but the YM3438 can source far more of it.

18:29 - Resistance was dropped to 510ohms on later Genesis revisions' power pins to the YM3438, not 560ohms.

38:24 - Just a clarification on the Super NES video warping at the top of the screen, it's only visible in the top overscan area. Within the actual video frame, the warping is not visible.

45:32 - 1Vpp is the voltage for Composite (combined signal and sync), what I meant to say there was 0.7Vpp, which is the voltage required for RGB (had Composite on my mind during that segment, for some reason).

Jaksot(907)

Weekly Roundup #501

Weekly Roundup #501

To help support the channel, please consider signing up for monthly services, or just use our affiliate links to purchase things you were already going to buy anyway, at no extra cost to you:  https:/...

18 Helmi 27min

Supporter Q&A #395

Supporter Q&A #395

Here's the Supporter-only Q&A from February 12th, 2026. All comments and questions are fielded through the supporter service Q&A page. Please consider supporting this channel via monthly support servi...

13 Helmi 30min

Weekly Roundup #500

Weekly Roundup #500

To help support the channel, please consider signing up for monthly services, or just use our affiliate links to purchase things you were already going to buy anyway, at no extra cost to you:  https:/...

11 Helmi 58min

Supporter Q&A #394

Supporter Q&A #394

Here's the Supporter-only Q&A from February 5th, 2026. All comments and questions are fielded through the supporter service Q&A page. Please consider supporting this channel via monthly support servic...

6 Helmi 27min

Weekly Roundup #499

Weekly Roundup #499

To help support the channel, please consider signing up for monthly services, or just use our affiliate links to purchase things you were already going to buy anyway, at no extra cost to you:  https:/...

4 Helmi 35min

Supporter Q&A #393

Supporter Q&A #393

Here's the Supporter-only Q&A from January 29th, 2026. All comments and questions are fielded through the supporter service Q&A page. Please consider supporting this channel via monthly support servic...

30 Tammi 33min

Weekly Roundup #498

Weekly Roundup #498

To help support the channel, please consider signing up for monthly services, or just use our affiliate links to purchase things you were already going to buy anyway, at no extra cost to you:  https:/...

28 Tammi 24min

Supporter Q&A #392

Supporter Q&A #392

Here's the Supporter-only Q&A from January 22nd, 2026. All comments and questions are fielded through the supporter service Q&A page. Please consider supporting this channel via monthly support servic...

23 Tammi 21min